BioGuard Power-Floc
BioGuard PowerFloc clears excessively cloudy
water. This product is ideal for use after a rainstorm or a period of time when your pump wasn't running (perhaps during a
vacation). The greater the amount of debris in the water, the faster it works. PowerFloc is very powerful flocculant. It settles
suspended particles to the bottom for removal by vacuum and makes water clear and sparkling.
Dosage - 8 fl oz per 10,000 gallons of water.
Cloudy Water
- Shake well before use.
- Check filter and backwash or clean filter if necessary.
- Adjust
pH to 7.5-8.0 for best results.
- Use at a rate of 8 fl. oz. per 10,000 gallons.
- Remove skimmer basket and any product
in the skimmer. Pour PowerFloc slowly into skimmer with the pump on and filter valve in recirculate or whirlpool position.
For filters without recirculate position: backwash, then with filter in filter position, dilute PowerFloc into large plastic
pail of water (8 fl. oz. of PowerFloc per 1 gallon of water, always add Powerfloc to water, never water to PowerFloc) and
apply evenly over surface of pool. Replace Skimmer basket after applying PowerFloc.
- Allow Pump to circulate water for
2 hours to distribute PowerFloc throughout the pool.
- Shut off the pump. Let PowerFloc settle debris to bottom whil pool
remains undisturbed for 12 to 24 hours ( usually overnight). Note: The greater the debris in the water, the faster PowerFloc
works. For extremely cloudy pools (cannot see the drain in the deep part of pool) use double the normal dosage.
- Vacuum all settled debris with filter
in waste or drain mode. Note: Settling may continue for several days if new debris is introduced by wind or rain. If so, vacuum
waste again. Do not vacuum debris through filter.
- Backwash and clean filter with BioGuard Kleen-It and resume normal
filter cycle.
- Check
pH and re-adjust if needed to 7.2-7.6
Item #23717BIO
|
